Seh-computertechnik TPG60 User Manual download pdf (Page 9)

General Information

TPG60 User Manual 9

TPG Default Name

The TPG name is made up of the two letters 'IC' and the device

number. The device number consists of the last six numbers of its

hardware address.

Fig. 2: Example: Default name

The TPG default name is found on the TPG Homepage, the

InterCon-NetTool, or the status page.

IP Address

The IP address is the unique address of each node in a network, i.e.

an IP address may occur only once on a local network. The system

administrator usually assigns the IP address. The address must be

saved in the TPG60 to make sure that it can be addressed within the

network.

Host Name

The host name is an alias for an IP address. The host name uniquely

identifies the TPG60 in the network and makes it easier to

remember.

Gateway

Using a gateway, you can address IP addresses from external

networks. If you wish to use a gateway, you can configure the

relevant parameter via the TPG Homepage or the InterCon-NetTool.

IC0001ff

Device

number

TPG Default Name

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 86 87

No comments

Seh-computertechnik TPG60 User Manual Page 9